KHSA is designed for the towing/recovery and rental industries. Used for transporting low clearance construction equipment, containers, agricultural equipment. It is built with an open frame design including cross-members helping eliminate the possibility of corrosion. Full width “greasable” rollers prevent flange roll up on beams and increase trailer life.
Quality
Design – Construction – Craftsmanship - On-Time delivery
Performance
Service Life - Light tare weight – Fabricated main beam & side rails
Safety
Low center of Gravity – Wireless winch controls - Warning decals – Tie downs
Value
Resale Value - Owner/Operator's cost - Factory tested - Payload
Customer Support
Dealer support - Technical Support - Product training – Factory Written Warranty
Specifications:
Capacity: 106,000 lbs distributed in 48’-0”, 70,000 lbs concentrated in 10’ 0”. GAWR & tire rating determine legal loads
Lengths: 53’ OAL, Upper deck 11’-6”,Lower 41’-6”
Load angle/Dump angle: 7o /16o
Swing Clearance: 96”
Upper Coupler: 48” king pin height, 2” pin, and 18” setting.
Hydraulics: PTO connection at front center, 15 GPM @ 2800 PSI. Two lift cylinders - 6“bore with restrictors on retraction side. Slide cylinders are 4 ½” bore single stage piggyback type for axle travel. Slide time is approximately 30 seconds. Controls located in roadside cabinet with aluminum door with stainless steel hinges.
Winch: 15,000 lb capacity planetary hydraulic winch located at front center of upper deck. Winch includes 100’ of ½” wire rope and shackle. Roller, 4” X 18”, centered at front of lower deck.
Remote control: Two function wireless remote for winch. System is air over hydraulics.
Cabinets: 27” X 16” X 16” on curbside rear upper deck with aluminum door including stainless steel hinges.
Landing Gear: 2 speed landing gear with roadside crank handle.
Deck heights, loaded: Upper deck 57 ½”” at front, lower deck height 38 ½” at rear at rated capacity
Beams: Four beam design. Minimum 100,000 psi yield flanges and 80,000 psi yield web. 14” deep main rails and 15” deep side rails.
Flooring: 1 5/16” Apitong with screws on every third cross member.
Cross members: 4” junior I-beams on 9” centers
Tie Downs: Tie down holes in top flange of both outer beams on approximately 36” centers. Double tie down holes in center plate of lower deck on approximately 36” centers
Slider: V-grooved center roller to provide self-centering. Two rollers per side with greasable bearings. Four slide pads on top of slider per side. Slider includes flex track to enclose air, electrical and hydraulic.
Suspension: Ridewell Model 240 Air Ride. No dump valve or manual raise & lower feature. 50” spreads
Axles: Three -OEM, 5” round with 5/8” wall, tapered spindles, 25,000 lb capacity.
Hubs: 8 stud, hub piloted, long studs, steel hub.
Drums: Cast drum
Seals: Oil
Brakes: 12¼” X 7½” Air. Parking brakes on all axles.
ABS: 4S/2M front & rear axle
Slack Adjusters: Automatic slack adjusters
Wheels: Steel disc wheels, 6.75 X 17.5.
Tires: OEM 235/70R17.5, 16PR (Low Profile) radial tires.
Mudflaps: Black anti-spray with Kalyn Siebert logo
Finishing(Paint and trim): Shot blasted prior to paint. Epoxy primer and black polyurethane paint. Aluminum diamond plate at rear of upper deck and rear lights. Air, electrical and hydraulic lines installed after painting is completed.
Lights & Electrical: Sealed beam with mid turn signal, 12 volt. 7-way plug.LED and additional lighting available
Conspicuity Tape: Discontinuous on sides
Manual: One operator manual per order will be provided. Parts manual available as option
Weight: 23,800 lbs + 3%. For trailers other than standard specification, weight and dimensional drawing will be provided by plant after order is received and accepted.
Warranty: Backed by five-year prorated frame warranty and three –year prorated paint warranty. One-year on remainder.
Options:
20,000 lb capacity planetary winch,5/8”cable
30,0000 lb capacity planetary winch,5/8”cable
Air Weigh System
20 HP Honda power package
Bulkhead,48” high both steel and aluminum
Rubrail,single pipe spools,2 ½” down from top flange
Pressure equalization system for tires
Stake pockets inside /pocket
Steel deck
Spare tire and wheel
Hub odometer
Aluminum wheels, polished or mill finish
Dock levelers ,62,000 lb capacity, independently operated
Dual power ,motor and PTO (valve)
Remote controls, wireless 4-10 functions
Central lube system
LED Lighting
Additional lights
Two tool compartments in front of gooseneck
Paint-color-contact RSM
Center plate flush with floor
Tie downs D-Rings
Working lights on Bulkhead
○ Customer Service ○ Warranty/Registration ○ Parts & Service
Market analytics
